| INDEX | NAME | DIRECTION | DEFAULT | UNIT | INFO |
|---|---|---|---|---|---|
| 0 | I.CurrentState | INPUT | 0 | Reports the current state of the switch | |
| 1 | I.ActivePower | INPUT | 0 | W | Reports the device power |
| 2 | I.Voltage | INPUT | 0 | V | Reports the device voltage |
| 3 | I.Current | INPUT | 0 | A | Reports the device current |
| 4 | I.PowerFactor | INPUT | 0 | Reports the device power factor | |
| 5 | I.Frequency | INPUT | 0 | Hz | Reports the device frequency |
| 6 | I.TotalEnergyConsumend | INPUT | 0 | W/h | Reports the total energy consumed by the device |
| 7 | I.CurrentPosition | INPUT | 0 | % | Reports the device current roller postion |
| 8 | I.TargetPosition | INPUT | 0 | % | Reports the device target roller postion |
| 9 | I.PositionControlEnabled | INPUT | 0 | N/Y | Reports if the device is calibrating for positioning control |
| 10 | I.LastDirection | INPUT | 0 | Reports the last direction of motion | |
| 11 | I.Temperature | INPUT | 0 | °C | Reports the device temperature |
| 12 | O.Open | OUTPUT | 0 | Command in roller mode to open while in motion | |
| 13 | O.Close | OUTPUT | 0 | Command in roller mode to close while in mation | |
| 14 | O.Stop | OUTPUT | 0 | Command in roller mode to stop whne not moving | |
| 15 | O.SetAbsPosition | OUTPUT | 0 | % | Command to set the absolute position |
| 16 | O.SetRelPosition | OUTPUT | 0 | % | Command to set the relative position |
| 17 | O.Calibrate | OUTPUT | 0 | Command to start the roller calibration | |
| 18 | O.RequestGlobalStatus | OUTPUT | 0 | UPDATE |